Remove the glass door by unscrewing the eight lock screws 3 and 4. Be careful to hold the glass door
firmly after removing the screws and place it on a padded surface to avoid the risk of damage.
Unscrew and transfer the door supporter 2 to the opposite side.
Rotate the glass door 180° and refit the glass door to the opposite side. Then screw and tighten it after
the door is leveled.
5. OPERATING INSTRUCTIONS
It is recommended that you installed your appliance in a place where the ambient temperature is
between 16-32°C. If the ambient temperature is above or below recommended temperatures, the
performance of the unit may be affected and it may not be possible to obtain temperature between 5-
20°C.
Temperature setting
ON/OFF switch, turn on by pressing once, turn off by pressing and holding 5 seconds.
. Light ON/OFF switch, turn on and turn off the light.
Temperature display in Celsius.
Temperature display in Fahrenheit
Display shows temperature at its setting. 5 seconds later, it will automatically turn to actual
temperature inside the wine cellar till reaching setting one.
. Decrease temperature of 1 degree Celsius or Fahrenheit
Raise temperature of 1 degree Celsius or Fahrenheit.
Temperature display
It is possible to adjust the temperature degree by degree; the temperature can be adjusted with the
keys or to the right of the temperature display. The temperature range of this cellar is
between 5°C and 20°C.
In normal operation, the display shows the temperature inside the cellar. When you increase or
decrease this temperature, the display will show the desired temperature. After a few moments, the
display will again show the temperature measured in the cellar.
To switch from degree Celsius to Fahrenheit press simultaneously on B and F
NOTE: when first used or after operating the wine cellar after a long period of inactivity, the inner
temperature will not immediately be the temperature shows on the display. Indeed, it is necessary to wait
a few hours for a temperature adjustment of the wine cellar in order to have a homogeneous temperature.
To avoid excessive condensation when the ambient temperature is above 28°C, do not lower the
temperature to below 7°C.
IMPORTANT: after unplugging, turning off the power or after a power failure, it is imperative to
wait 5 minutes before turning it on again.
To Next Page
Loading...
Need help?
General
