Temperature alarm
The alarm will sound and the temperature display will flash when:
- The temperature rises or falls outside the temperature range (5-20°C)
- You switch the appliance on, if the temperature inside the appliance is very different (+/- 4°C)
from the temperature set after 7 hours working
- Too many items have been put into the unit at one time, and the temperature inside the appliance
is very different (+/- 4°C) from the temperature set after 7 hours working
- The door has not been closed tightly
Door alarm
If the door has been left open for more than 60s, the alarm will sound. Once the set temperature has
been reached in the appliance, the alarm stops and the relevant temperature display stops flashing.
However, if the noise disturbs you, you can switch the alarm off before this if you wish by pressing the key
I once. The alarm will stop. The relevant temperature display continues to flash until the set temperature
has been reached. The display then lights up constantly and the alarm system is fully active again.
Interior light
The interior light makes it easy to view your wines labels and enhances the display of your collection.
Touching the mark (B) toggles between two modes of operation for the internal lights:
- Functional mode (default): the light will turn on only when the door is open, this is the most
economic mode
- Showcase mode: the lights will be on whether or not the door is open. To turn this permanent light
mode and get back the default mode, please push again the light button (B).
Dynamic climate / silent mode
Wine cellars are designed to preserve your wines in perfect conditions over long periods in complete
safety. However, no frost systems can cause noise, this is the reason why the silent mode is the default
factory setting. Thus, you can switch off the silent mode to switch to the ventilated cooling mode by
pressing the key “+” (G) for 5 seconds. The cellar will emit 5 sound signals to confirm the passage in
ventilated cooling mode. Conversely, to deactivate the ventilated cooling mode and return to the default
silent mode, press and hold the key “-” (F) for 5 seconds. The cabinet will emit 3 sound signals to confirm
the silent mode. When this function is activated, the distribution of the temperature in the cavity is not so
uniform, small temperature differences can be observed between the top and bottom of the cellar.
Modes
SABBATH MODE
Sabbath mode is available for the observance of certain religious holidays. This mode turns off the
displays, interior light and audible alarms and prevents them from turning on again. Normal cooling
operations will still take place. To initiate sabbath mode, press the power (A) and light (B) keys at the
same time for at least 5 seconds. The indicator light will flash four times and confirm the sabbath mode is
ON. Sabbath mode can be stopped by repeating the above process. The sabbath mode will automatically
exit after 96 hours.
ECO DEMO MODE
Eco demo mode can be activated by presenting the appliance at exhibitions, shows or in salesrooms. In
eco demo mode, compressor and all fan motors are switched OFF. By pressing and holding the “+” and “-
” (G and F) keys at the same time for at least 5 seconds, the indicator light will flash five times to confirm
the input and the unit will operate in eco demo mode. Eco demo mode can be abandoned by repeating
the above process, be noted that compressor and fan will activate 5 minutes later (for compressor
protection reason).
To Next Page
Loading...
Need help?
General
