Welcome to your new ClimeMET CM9088 Forecast Station. To make setup as easy as possible, follow our

guide below. You can then refer to the manual for additional functionality.

Setting the Time

The first step is to ensure the time you are seeing on the console is correct. This unit picks up the DCF-77 Radio

Signal broadcast from just outside Frankfurt in Germany, and your CM9088 will synchronise to this signal once

a day to maintain accuracy. If you set the time manually, every time the radio signal is picked up, it will

overwrite your manual setting. For this reason, you should change the time zone, rather than the time.

The time zone should be set to 0 for the UK.

To change the Time Zone setting if needed, push and hold the SET key until the console beeps and the time is

replaced by a single flashing digit. This is your Time Zone value. While this is flashing, simply press the ‘+’ or

'MIN/MAX' key (which works in this instance as -) to adjust this value as required. Again, Time Zone ‘0’ is

GMT, for use within the UK. Once you've changed this, don’t touch any buttons for around 30 seconds and it

will save this setting and revert to the home screen.

When you change the time zone from 1 to 0, the time displayed will instantly decrease by one hour.

However, please note that it may take several hours after changing the time zone for the CM9088 to pick up

the signal and adjust the time that is displayed to the current time.

Once this is set, it means that when the DCF-77 signal is received, your station will adjust the time accordingly

so that the time is always correct for your time zone.

Setting Sunrise and Sunset

We advise waiting until your station is displaying the

correct time before proceeding with setting the

sunrise and sunset.

You will next need to ensure that the Latitude and

Longitude values are accurate. It's possible to enter

these values in an incorrect format or the wrong way

round, but once entered correctly, your station will

adjust the sunrise and sunset times automatically.

Start by determining your co-ordinates. The best way

to do this is to use Bing Maps

(http://www.bing.com/maps/). Enter your post code

to quickly find your general location and then zoom in

using the + key. Right-click any point on the map to

view the co-ordinates. A small box should pop up on

the map stating ‘Coordinates’ followed by your

Latitude and Longitude. Latitude for the UK tends to

be between 50-58 North, and Longitude will range

from roughly 8 West to 1.7 East.

ClimeMET CM9088 - Instruction Handbook Manual

Other manuals for ClimeMET CM9088