BUTTONS ON HEIMDALL
Their functions
BUTTONS ON HEIMDALL
Their functions
It is always possible to reset HEIMDALL if any issues occur.
1. Press and hold Volume “+” and Volume “-” down
simultaneously for 3-4 seconds to perform a system reset.
2. When the LED’s turns off release the buttons. Wait until
HEIMDALL has rebooted. HEIMDALL will say: “No device
connected” and then – “Please reconnect your device”
(See page 9 for connecting to network).
Pressing the “ ” button will switch HEIMDALL between
single speaker mode and MultiRoom (WHA) mode.
The rst speaker is set as MASTER and the rest will be set
as SLAVES.
Note: Read more about MultiRoom (WHA) on page 22.
1. Press the “+“ to turn the volume up.
2. Press the “-” to turn the volume down.
Volume Up / Down:
Reset:
MultiRoom (WHA):
1. Press the “ “ to mute the music.
2. Press the “ “ again to un-mute the music.
Mute:
1. Press “ “ to power on HEIMDALL.
2. Press and hold “ ” to power off HEIMDALL.
Power On / Off:
1. Press ” “ button to pause music.
2. Press “ “ again to play music.
Play / Pause:
1817
Warning: When performing a RESET all settings will be deleted and
HEIMDALL will return to the factory default settings.
To Next Page
Loading...
General