Need help?Do you have a question about the ClipperCreek ProMountDuo PMD-10T and is the answer not in the manual?
Instructions for preparing the required hardware and trimming the flexible conduit for HCS EVSE installation.
Steps for inserting the HCS EVSE wires and securing the unit to the pedestal's top panel.
Details on connecting the ground conductor and other service wires for the HCS EVSE.
Guidance on proceeding to the next steps based on whether a single or dual mount HCS EVSE is installed.
Steps for installing the LCS/ACS EVSE, including conduit fitting and securing the unit to the top panel.
Instructions for completing the ground conductor and service conductor wiring for the LCS/ACS EVSE.
Guidance on next steps based on single/dual mount or other EVSE types on the opposite side.
Details on preparing the Tesla EVSE unit and its associated mounting hardware.
Instructions for preparing the pedestal side, including removing caps and installing bushings.
Steps for installing the top entry bracket and conduit plugs for the Tesla EVSE.
Guide to disassembling and preparing the Tesla Wall Connector EVSE for mounting.
General| Mounting Type | Wall Mount |
|---|---|
| Enclosure Rating | NEMA 4 |
| Number of Connectors | 2 |
| Number of Ports | 2 |
| Charging Levels | Level 2 |
| Cable Length | 25 ft |
| Connector Type | J1772 |
| Operating Temperature | -30°C to 50°C |
| Input Voltage | 208-240 V AC |
| Charging Connector | J1772 |
To Next Page
