CLIVET AQX CLA Series User Manual

28
9 - TROUBLESHOOTING
WATER DRAGGED THROUGH THE ELIMINATOR
 Excessive air flow-rate
 Excessive water flow-rate to the humidifier
 Defective seal on the eliminator
INSUFFICIENT HUMIDIFICATION
 Dirty water filter
 Dirty nozzles
 Deposits in the wet deck
 Insufficient water level in the tank, due to defective control by
the float or accidental leaks
POOR COIL HEATING CAPACITY
 Insufficient temperature or flow-rate of the thermal carrier fluid
 Reduced air flow-rate
 Air in the coil. Vent.
 Automatic control malfunctioning
 Condensate discharge malfunctioning (steam coils)
EXCESSIVE NOISE
 Slipping of the belts
 Defective bearings
 Magnetic howling of the motor due to a voltage drop or
manufacturing defect
 Foreign material in the fan shroud
 Vibration of the damper fins
 Howling due to vibration of the ducts, baffles, outlets, diffusers
 Loosening of the wheel on the shaft
 Loose fan cut-off
 Loose motor cooling fan
 Excessive air flow-rate

CLIVET AQX CLA Series Specifications

General

Brand	CLIVET
Model	AQX CLA Series
Category	Air Handlers
Language	English