To Next PageTo Next PageWhy is my CLIVET Box-SM 2 650x650 Air Conditioner not working?
Your CLIVET Air Conditioner might not be working due to several reasons: a power failure (wait for the power to be restored), the power switch being off (turn on the power), a burned-out fuse (replace the fuse), dead remote control batteries (replace the batteries), or the unit’s 3-minute protection being activated (wait three minutes after restarting the unit).
What to do if my CLIVET Box-SM 2 650x650 has poor cooling performance?
If your CLIVET Air Conditioner isn't cooling well, it could be due to several factors. First, ensure the temperature setting is lower than the room temperature. Other potential causes include a dirty heat exchanger (clean the heat exchanger), a dirty air filter (remove and clean the filter), blocked air inlet or outlet (turn the unit off, remove the obstruction, and turn it back on), open doors and windows (keep them closed), excessive heat from sunlight (close windows and curtains), or low refrigerant (check for leaks, re-seal if necessary, and top off refrigerant).
Why does my CLIVET Air Conditioner start and stop frequently?
Your CLIVET Air Conditioner might be starting and stopping frequently due to several reasons: * Too much or too little refrigerant in the system (check for leaks and recharge the system). * Air, incompressible gas, or foreign material in the refrigeration system (evacuate and recharge the system). * A blocked system circuit (determine which circuit is blocked and replace the malfunctioning piece of equipment). * A broken compressor (replace the compressor). * Voltage that is too high or too low (install a manostat to regulate the voltage).
How to fix poor heating performance on CLIVET Air Conditioner?
If your CLIVET Air Conditioner is not heating well, it could be because the outdoor temperature is lower than 7°C (44.5°F). Other causes include cold air entering through doors and windows (ensure they are closed) or low refrigerant due to a leak or long-term use (check for leaks, re-seal if necessary, and top off refrigerant).
General| Brand | CLIVET |
|---|---|
| Model | Box-SM 2 650x650 |
| Category | Air Conditioner |
| Language | English |
Lists optional accessories such as remote controllers and decoration panels.
Provides essential information and precautions regarding the use of fluorinated gasses.
Outlines the sequence of installation steps with visual aids and page references.
Details indoor unit components and specific safety warnings for installation.
Covers installation steps, location selection, and recommended ceiling distances.
Guidance on selecting an installation location and mounting the outdoor unit.
Instructions for installing the drain joint and drilling a hole in the wall.
Important cautions and notes for proper drainpipe installation and purchasing.
Details on indoor drainpipe installation and connecting multiple drainpipes.
Specifies maximum pipe length and drop height requirements based on models.
Guidance on installing oil traps and minimum bend radius for refrigerant pipes.
Detailed steps for cutting, removing burrs, flaring, and connecting refrigerant pipes.
Covers safety warnings, power specifications, and cable size requirements for wiring.
Step-by-step instructions for wiring the outdoor and indoor units.
Important safety warnings and procedures before performing air evacuation.
Detailed steps for evacuating the system using a vacuum pump and manifold gauge.
Instructions for removing the front grille and attaching the decoration panel.
Steps for mounting the intake grille and connecting wires from the panel.
Confirms all installation points are correct before performing the test run.
Guides on performing the test run for indoor/outdoor units and a drainage test.
Explains WEEE directives, definitions of household/professional WEEE, and disposal requirements.
Safety checks, work procedures, and general area precautions for flammable refrigerants.
Covers refrigerant checks, electrical safety, and repairs to sealed components.
Details leak detection methods, refrigerant removal, and evacuation processes.
Provides technical specifications for multi-split units including refrigerant lines and electrical connections.
Lists technical specifications for light commercial units, including refrigerant lines and electrical connections.
