Specifications
Page 16
C.Micro-switch SW3 is for selection of auto-restart function.
Range: Active, inactive
SWITCH
FOR MODE-PRIOR SETTING
ON
STATE
MODE
HEAT
Factory
Setting
ON
12
ON
1 2
ON
1 2
ON
12
HEAT
COOL
COOL
SW5
D. Micro-switch SW5 is for setting mode priority of multi connection.
Range: Heat, cool.
E.Micro-switch SW6 is for selection of temperature compensation in heating mode. This helps to
reduce the real temperature difference between ceiling and floor so that the unit could run properly.
If the height of installation is lower, smaller value could be chosen.
Range: 6
o
C, 4
o
C, 2
o
C, E function (reserved for special customizing)
SWITCH
FOR COOLING & HEATING
SW7
ON
STATE
MODE
COOLING&
HEATING
COOLING
ONLY
ON
ON
Factory
Setting
OR COOLING ONLY
SETTING
F. Micro-switch SW7 is for setting cooling &heating or cooling only.
Range: cooling &heating, cooling.
To Next Page
Loading...
Need help?
General
