Clover Flex Quick Start Guide

English 4
Set Up your Clover Flex
A micro SIM card may be pre-installed in the device. See
page 9 for instructions on how to replace the SIM.
Plug the power brick into the charging cradle and press the
cord into the rubber base so that it is ush on the counter.
Attach the power cord to the power brick and plug the
power cord into a power source.
Place the device on the charging cradle. If it's properly
connected, a battery icon will briey appear on the screen.
While it charges, press and hold the power button until the
Clover logo appears on the screen.
Follow the on-screen instructions to continue setting up.
1
2
4
3
5
1
2
3
5
4

Clover Flex Specifications

General

Memory	1 GB RAM
Connectivity	Wi-Fi, Bluetooth, 4G LTE
Operating System	Android
Card Reader	EMV Chip Card Reader, NFC Contactless Reader, Magnetic Stripe Reader
Storage	8GB Flash
Camera	5MP Rear-facing camera
Ports	USB-C, 3.5mm audio jack
Payment Options	Magstripe, EMV, NFC
Security	PCI PTS V5.0
Processor	Quad-core ARM Cortex-A7