Operating
This product works well on tiles, low-pile carpet (lower than 1.5cm), wooden
floor and hard floors.
Caution: Do not use it on the ground with water
Scope of Application
Tiles Wooden Floor Linoleum Low-pile carpet
Power on/Pause/Sleep
Sleep mode means the robot stops and the screen is also dark.
A. The robot will enter sleep mode after leaving it untouched for 20 seconds.
Attention: Turn off the power completely for storage.
Sleep
A. Make sure to turn on the power switch at the bottom.
B. Press the CLEAN button on the remote or the robot to start cleaning.
Power on
Pause means to switch from working to selection mode, and the
following operation can pause the robot：
A. Pause the robot by pressing any button on the screen;
B. Press the CLEAN button on the remoter to pause;
Pause
B. Press on the CLEAN button on the screen for 3 seconds, then it will enter sleep mode.
9
To Next Page
Loading...