Clymen Q7 - Maintenance Procedures; Side Brush Maintenance; Dustbin and Filter Cleaning

Maintenance
Cleaning side brushes
A. Status check: Check if the side brushes are damaged or dirty.
B. Clean side brushes with the small brush or a soft cloth.
C. Replace the side brush that is too damaged to work.
Cleaning the dustbin and filters
A. Press the "PUSH" sign on the cover to open the lid on top;
B. Remove the dustbin；
C. Remove the HEPA filter；
D. Open the dustbin cover and remove the primary filter；
E. Remove the dirt in the dustbin；
F. Clean the dustbin and primary filter with water and clean HEPA filter with the small brush；
2. It is recommended to clean the HEPA filter after 15-30 days of use; the maximum life span
of a HEPA filter is 24 months.
G. Install the primary and HEPA filters back into the dustbin;
Attention: 1. Make sure the primary and HEPA filters are completely dry before putting them back;
2. Do not place primary and HEPA filters under direct sunlight.
H. Cover the dustbin and install it back to the robot.
Attention: Primary and HEPA filters are a replaceable part.
Attention: 1. When the dustbin sign lights on the screen with the "!" sign, please clean the dustbin and suction
tunnel immediately;
13