CM RX-600 - 4.2. Safety in Use.; 4.3. Ensuring Hygiene; 5. Preparing to Work; 5.1. Machine Placement.

4.2. Safety in use.
Paddle mixer RX-600 operators should be aware of the threats and aftermath the machine
can pose, also should know the purpose and operation of protective devices installed on the
machine.
 While using the RX-600 machine, operator should be guided by the informations and
recommendations contained in this user manual,
 Troubleshooting, carry out repairs and any other activities associated with the
machine maintenance in standby mode may perform only authorized persons.
 Any work i.e. troubleshooting, repairs, maintenance, lubrication and cleaning, always
perform while power supply is off.
 Any modifications and manipulations of the bypass protective devices, in particular
with regard to blockades and covers are prohibited because the machine is no longer
safe.
 It is forbidden to walk on the machine, top flap and any other components
(e.g. covers), to grab actuators, etc.
 It is forbidden to put hands under ejection flap,
4.3. Ensuring hygiene
Used materials and the paddle mixer RX-600 construction meet the following requirements:
 The machine is made entirely of stainless steel in such a way as to prevent retention
of product remains which decomposition could create a bacteriological risk
 The device is standing on four legs and the bottom is sufficiently spaced from the
ground, on which stands the stuffing mixer. It allows to keep clean under and around
it.
 Proper legs adjustment and mixer positionig allows thorough washing, drying tank
and mixing paddles.
 Paddle mixer RX-600 used as intended does not pose a risk to human health.
5. Preparing to work
5.1. Machine placement.
After setting the machine to the desired location, adjust the legs so that the bottom of the
tank was slightly (about 2%) inclined towards the stuffing outlet.
6