Name: CMA Dishmachines UC65e
Brand: CMA Dishmachines
Rating: 4 (1 reviews)

Other manuals for CMA Dishmachines UC65e

Installation & Operation Manual68 pages

Questions and Answers:

D
Dawn JohnstonJul 31, 2025
Why is my CMA Dishmachines UC65e Dishwasher not washing properly?
- I
  Ivan CaldwellJul 31, 2025
  If your CMA Dishmachines Dishwasher isn't providing satisfactory wash results, make sure that the wares are correctly loaded in the dishrack, repositioning them or reducing the amount if necessary. You should also check and clean the sump filter and spray arms. If the detergent injector isn't feeding, replace the squeeze tube or clean the tubing and pick-up tube. For thermostat or detergent motor issues, or low water temperature, it is recommended to contact a service agent.
V
Vincent MartinezAug 6, 2025
How to fix a CMA Dishmachines Dishwasher that will not run?
- B
  Brendan PowellAug 6, 2025
  If your CMA Dishmachines Dishwasher won't start, ensure that the door is completely closed and the main power is turned on. Also, verify that the dishwasher itself is switched on. Check the breaker on the panel.
C
carrolljulieAug 12, 2025
What to do if CMA Dishmachines UC65e stays in wash cycle?
- S
  Sandra DouglasAug 12, 2025
  If your CMA Dishmachines Dishwasher is staying in the wash cycle, it might be due to the Safe-T-Temp feature extending the wash mode to ensure the final rinse water booster temperature reaches 180°F/82°C, or the dishwasher might be operating in the Extended Wash Mode. To resolve this, press the Extended Wash button once to turn off the Extended Wash Indicator light, which should allow the wash cycle to resume and perform the final rinse cycle. If the issue persists, it is recommended to contact a service agent, as the booster thermostat may be defective.
C
Craig MooreAug 18, 2025
Why are chemicals not feeding into my CMA Dishmachines Dishwasher?
- A
  Alison SantosAug 18, 2025
  If chemicals aren't feeding into your CMA Dishmachines Dishwasher, first check the chemical supply and refill the container if it's low. Also, inspect the pick-up tube for clogs and clean or replace it if necessary. Examine the supply tubing for damage or kinks; replace or straighten the tubing as needed.