CMi C-LK 140/24/8 OF - Operating pressure vessels; Layout

2. Layout
35
GB
466789 V_01/06/2010
• It is imperative to use filtering equipment (face masks) when processing harmful liquids. Note
also the information concerning safety precautions published by the manufacturers of these
liquids.
• Smoking is prohibited during the spraying operation and in the work room. Paint vapours are
highly flammable.
• Make sure there are no open fires or open lights in the work room. Sparking machines are not
to be used.
• Do not keep or consume food and drink in the work room. Paint vapours are harmful.
• The details and designations of the Ordinance on Hazardous Substances, which are displayed
on the outer packaging of the processed material, must be observed. Additional protective
measures are to be undertaken if necessary, particularly the wearing of suitable clothing and
masks.
• The work room has to be bigger than 30m³ and have sufficient ventilation for spraying and dry-
ing. Never spray into the wind. It is always imperative to observe the regulations of your local
police authorities when spraying combustible or hazardous substances.
• Never process media such as white petroleum spirit, butyl alcohol and methylene chloride with
the PVC pressure hose (reduced life span).
1.4 Operating pressure vessels
• An operator of a pressure vessel is required to keep the pressure vessel in good working order,
to operate it properly, to supervise its use, to carry out essential maintenance and repair work
immediately, and to introduce essential safety measures according to requirements.
• The supervisory authorities may order essential safeguards from case to case.
• A pressure vessel may not be operated if it has any defects which constitute a danger to employ-
ees or third parties.
• The pressure vessel must be regularly inspected for damage, e.g. rust. If you discover any dam-
age, then please contact the customer service workshop.
Keep these safety instructions in a safe place.
2. Layout
1. Housing cover
2. Pressure vessel
3. Wheel
4. Supporting foot
5. Quick-lock coupling (regulated compressed air)
6. Pressure gauge (for reading the preset tank pressure)
7. Pressure regulator
8. ON/OFF switch
9. Transportation handle
10. Safety valve
11. Drainage screw for condensation water
12. Pressure gauge (for reading the tank pressure)
13. Intake air filter
466789.book Seite 35 Mittwoch, 16. Juni 2010 11:05 11