8 Specifications subject to change without notice. 32802000102
Timer Function
TIMER ON (to start the unit) and TIMER OFF (to stop the unit)
can be used separately or together.
Timer ON only
This function allows the unit to start automatically at the set time.
The TIMER ON function can be set while the unit is on or off.
UNIT ON
a. Press SET until an indicator TIMER ON
appears and flashes. By default, the last time period
that you set and an "h" (indicating hours) appear on
the display. Every time TIMER ON is pressed,
the time increases by 30 minutes, up to 10 h. It
increases by 60 minutes, afterwards, until the time
settings reach 24 h.
b. Press
and repeatedly to set the time when you
want the unit to turn on.
c. Wait 3 seconds, the TIMER ON function
activates. The digital display on your remote control
will then return to the temperature display. The
indicator remains on and this function activates.
Adjust the TIMER ON settings to 0.0 to cancel this option.
Timer OFF only
This function allows the unit to stop automatically at the set time.
The timer can be set while the unit is on or off.
UNIT ON
a. Press SET until an indicator TIMER OFF
appears and flashes. By default, the last time
period that you set and an "h" (indicating hours)
will appear on the display.
NOTE: This number indicates the amount of time
after the current time that you want the unit to turn
off.
Every time TIMER OFF is pressed, the time
increases by 30 minutes, up to 10 h. It increases by 60
minutes, afterwards, until the time settings reach 24 h.
b. Press and repeatedly to set the time when you
want the unit to turn on. Wait 3 seconds, then the
TIMER OFF is activated. The digital display
on your remote control reverts to the temperature
display. The indicator remains on and this function
is activated.
c. Adjust the TIMER OFF settings to 0.0 to cancel this
option.
Setting both TIMER ON and TIMER OFF at the same time
Use both functions to program the unit to turn on and shut off at
specified times.
UNIT OFF
a. Set TIMER ON as previously described.
b. Set TIMER OFF as previously described.
The unit starts automatically at the set TIMER ON
and turns off at the set TIMER OFF .
UNIT ON
a. Set TIMER OFF as previously described.
b. Set TIMER ON as previously described. The
unit turns off automatically at the set TIMER OFF
and turns on at the set TIMER ON .
Sleep Mode
SLEEP mode is used to conserve energy and can be used when
the unit is in the COOL, HEAT or AUTO mode only.
Cool Mode
Push SET until the SLEEP icon appears, then push or
to activate. After 1 hour, the set point raises by 2°F (1°C).
After another hour, the set point raises by another 2°F (1°C) and
the fan runs in a low speed. The unit shuts off 7 hours after
setting the SLEEP mode. The SLEEP mode cancels if either
“Mode”, “TEMP”, “Fan”, “Timer”, or “On/Off” on the
remote control is pressed.
Heat Mode
Same as the COOLING mode however the set points are lowered
by 1.8 F (1C).
NOTE: The SLEEP mode is not available in AUTO, FAN
or DRY mode.
Turbo Mode
Use TURBO mode to cool or heat the room rapidly.
a. Press SET until TURBO appears on the remote
control, then push and to activate. An audible
“beep” is heard if the indoor unit supports this
function. The fan runs on super high speed.
TURBO terminates automatically 20 minutes after
pressing TURBO. It can be terminated immediately
by selecting the TURBO mode again. When the
TURBO mode is terminated, the unit reverts to the
original setting.
NOTE: The TURBO mode is not available in the FAN or
DRY modes.
To Next Page
Loading...