CMT CMT-300 - Getting Started; Connecting the Inserting the CMT-300 Module; Removing the CMT-300 Module

72 pages

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

Section

1

GETTING

STARTED

Connecting

the

CMT-300

to

the

HP-41

CAUTION:

Turn

the

HP-41

calculator

off

before

The

inserting

or

removing

the

CMT-300

or

any

other

plug-in

extensions

or

accessories.

Failure

to

do so

could

damage

both

the

calculator

and

the

plug-in

module.

cable

connecting

the

CMT-300

to

the

plug-in

connector

has

built-in

strain

relief.

Bend

it

into

a

shape

that

allows you

to

work with

the

CMT-300

and the

HP-41

conveniently.

Inserting

the

CMT-300

Module:

1.

Turn

the

HP-41

off!

Remove

the

port

cover

of

the

port

you

intend

to

insert

the

CMT-300

into.

Note,

however,

that

you should

never

insert

the

CMT-300

or

any

other

application

module

into a lower

numbered

port

than

a

RAM

memory

module.

(Turn

your

calculator

over

to see a

map

of

the

ports.)

Insert

the

CMT-300

connector

into

the

selec-

ted

port.

Gently

push

it

in

all the

way.

If

you

are

also

using

the

HP-IL

module

or

other

application

modules, plug them

into

any

port after

the

last

memory

module

plugged

in.

You

may

leave

gaps

in

the

port

sequence.

Turn

the

calculator

on.

If

the

interface

loop

is

used,

be

sure

all

the

peripheral

devices

are

properly

connected

and

turned

on

before

turning

the

calculator

on.

This

will ensure

proper

auto-addressing.

Removing

the

CMT-300

Module

1.

2.

3.

Turn

the

HP-41

off!

Grasp

the

CMT-300

connector

and

pull

it

out.

Insert

a

port

cap

into

the

empty

port.