CMT CMT-300 - Mass Storage Medium; Automatic Data Logging

Section 3
AUTOMATIC DATA LOGGING
The application programs "DLOG" (Data Log) and
"PSSR" (Print/Store/Save/Record) permit data log-
ging to be carried out without user intervention.
Once the initial conditions have been set up, you
can leave the system alone. The HP-41 and the
CMT-300 will be turned on to make measurements at
a specified time or at given time intervals. Both
devices will be turned off automatically between
measurement runs. The HP82182A Time Module will
be required if the HP-41C or HP-41CV calculator is
to be used to run this program.
You may store the measurement results in the HP-41
memory (data registers or Extended Memory), on a
mass storage medium (tape or disk), or by means of
any other storage device compatible with the
system.
The keys used in this operation are defined by the
keyboard overlay provided with your CMT-300. The
labels are on the right-hand side of the keys.
While the "DLOG" program is running, the following
options are available:
Range Selection 1X 1X 10X 100X 1000X
Mode Selection VDC ADC VAC AAC KOHM
Autorange AR
To execute this program, key in the sequence [XEQ]
[ALPHA] DLOG [ALPHA]. Alternatively, assign
"DLOG" to a key by pressing [SHIFT] [ASN] [ALPHA]
DLOG [ALPHA] [destination key]. You can now
execute 'DLOG" by simply pressing the reassigned
key in the USER mode.
* This program does not reassign any of the
calculator keys, nor does it use any local
alpha labels.
15