CMT CMT-300 - Reference

72 pages

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

LIMITS

This

option

allows you

to

specify

the

upper

and

lower

limits

of

a

range

of

interest.

If

the

upper

limit

is

higher

than

the

lower

limit,

a

beep

will

be

sounded

when

a

reading

falls

outside

of

these

limits.

If

the

upper

limit

specified

is

lower

than

the

lower

limit,

the

calculator

will beep

when

a

reading

is

inside

the

limits.

This

option

can

be

very

useful

in

component

testing.

To

activate

this

option,

press

the

[LMTS]

key.

Flag

05

will

be

set

when

this

option

is

active.

When

prompted

with

"UPPER

LMT?", key

in

the

desired

value

and

press

[R/S].

If

you

do

not key

in

any

value

before

pressing

[R/S],

that

parameter

will

remain

the

same

as

before.

The

default

upper

limit

is

9

x

107.

You

will

then

be

prompted

with

"LOWER

LMT?".

Respond

as

for

the

first

prompt.

The

default

lower limit

is

-9

x

107.

To

abort

this

option,

press

[LMTS]

again

and

input

the

same

value

(eg.

0)

for

both

prompts.

Remark:

If

you

will

be

invoking

the

REFERENCE

or

CUSTOM

PROGRAM

options

described

below,

specify

the

upper

and

lower

limits

with

respect

to

the

values

obtained

after

the

readings

have been

modi-

fied

by

those

operations.

REFERENCE

This

option

allows you

to

compare

the

readings

against

a

given reference

value.

There

are

3

possible

modes:

1)

OFFSET

mode

-

the

displayed

reading

represents

the

actual

reading

less

the

reference

value.

This

is

the

default

mode.