CO/Tech E0666TH - Page 6

6
ENGLISH
Synchronisation
1. Place theunits close to eachother.
2. Make sure that thechannel selector (26) is set to channel 1.
3. Synchronisation will begin automatically once all batteries are inplace.
4. Theweather station will automatically display readings from channel 1 (if CH 1
does not show (3), press [ CH/▲ ] repeatedly until CH 1 shows).
5. If theoutdoor temperature shows (readings from thesensor) on theweather
station’s display, synchronisation is complete.
6. Theunits can now be placed at their desired locations. Note: Maxrange: 30m.
Adding additional sensors using channels 2 and 3
Theweather station can be supplemented by theaddition of two extra sensors
(soldseparately). Makesure that each sensor is assigned its own channel.
1. Choose asensor that you wish to broadcast on channel 2 and open its battery
compartment.
2. Set thechannel selector (26) to channel 2.
3. Observe themarkings on thebottom of thebattery compartment and insert
2×AA/LR6 batteries.
4. Refit thebatterycover.
5. Press and hold in [ CH/▲ ] until thesignal icon (4) begins toflash.
Theweather station will begin searching for theoutdoor sensor.
6. Press [ CH/▲ ] repeatedly on theweather station until CH 2 appears (3).
7. After ashort moment, thereadings from channel 2 will appear on theweather station.
8. Repeat thesame procedure for setting another sensor to channel 3, if needed.
Placement/mounting
Weather station
• Theweather station has integrated temperature and moisture sensors. Becareful
when placing theunit so that it is not located near heaters, cookers, or other heat
sources.
• Theweather station can be used with its table stand (23) or hung on awall using
its eyelet (22).
• Avoid placing theunit next to metal objects such as metal window frames as this
may cause interference with reception.
Sensorunit
• Place thesensor in alocation that is protected from direct sunlight andrain.
• Mount thesensor at least 2.5 m above ground, if possible.
• Fasten ascrew to thewall and hang up thesensor from its eyelet (25).