5
ENGLISH
Setting a weekly programme (example)
MO - FR 08.15 ON / 15.45 OFF
1. Press MENU until you come to programme 1 ON.
2. Press OK once until day of week is flashing. Use +1 or -1 to select a weekly
combination. For example MO, TU, WED, THU, FR.
3. Press OK, the hours will start flashing. Set the hours using the +1 or -1 key.
4. Press OK, the minutes will start flashing. Set the minutes using the +1 or -1 key.
5. Press OK, now “1 ON” starts flashing, use +1 to select programme 1 OFF.
NOTE: In order to be sure that the programme is activated, “AUTO ON” or
“AUTO OFF” must be displayed in time display mode.
Deactivating a programme
1. Press MENU and select programme 1 ON.
2. Use the +1 (forward) or -1 (backward) key to select the programme
to be deactivated.
3. Press RCL. ON and OFF programmes must be
deactivated individually. See fig. 4.
Countdown timer
The connected device can be turned on or off after the expiration of the set time.
1. In time display mode, use +1 to select ON or OFF.
2. Press MENU and select programme CTD. The hours will now start to flash.
Set the hours using the +1 or -1 key.
3. Press OK, the minutes will start flashing. Set the minutes using the +1 or -1 key.
4. Press OK, the seconds will start to flash. Set the seconds using the +1 or -1 key.
5. Press OK to run.
6. Press RCL to exit the countdown function. See fig. 5.
Random function
1. In time display mode, use -1 to select ON or OFF. The display shows “RND”.
2. The display must show “AUTO OFF” for the programme to work.
3. This causes the set on and off times to be
delayed by 4–32 minutes.
4. To deactivate the random function, press -1
again and “RND” disappears from the display.
See fig. 6.
fig. 4
fig. 5
fig. 6
To Next Page
Loading...
General