Coaster 460182 - Hardware Identification

HARDWARE IDENTIFICATION
METAL DOWEL
LONG BOLT
SHORT BOLT
FLAT HEAD SCREW
BARREL NUT
(5/16 x 80 x 13mm - BLK)
(5/16 x15mm - BLK)
(1/4 x 35 x 15mm- BLK)
(12 x 125mm - BLK)
(4 x 35mm - BLK)
Z - ALLEN WRENCH
ALLEN WRENCH
(65 x 64MM - BLK)
1
19PCS
2
3
19PCS
19PCS
5
6
7
4
1PC
1PC
4PCS
80PCS
PAGE 3 OF 9
NOTE:
Phillips head screw driver is required in the assembly process; however, manufacturer does not provide this item.
COASTERFURNITURE.COM
ASSEMBLY INSTRUCTIONS
ITEM: 460182 (B1-B3)
1. Remove hardware from box and sort by size.
2. Please check to see that all hardware and parts are present prior to start of assembly.
3. Please follow attached instructions in the same sequence as numbered to assure fast & easy assembly.
ASSEMBLY TIPS:
WARNING!
1. Don’t attempt to repair or modify parts that are broken or defective. Please contact the store
immediately.
2. This product is for home use only and not intended for commercial establishments.
(20 x 50 x 50MM - BLK)
Z-B2 (BOX2) - HARDWARE PACK IS LOCATED IN 460182 (B2)
WOOD CLEAT
(20 x 45 x 50mm)
8
4PCS