Coaster 460441 B1-B4 - Parts Identification; B1 (Box 1) Parts; B2 (Box 2) Parts; B3 (Box 3) Parts

ITEM:460441 (B1-B4)
ASSEMBLY TIME
A
LEFT
BED END
1PC
ROLL SLAT
(13PCS)
2SETS
B
MIDDLE
BED END
1PC
I
TOP LADDER
STEP
1PC
D
GUARDRAIL
4PCS
K
MIDDLE
LADDER STEP
WITH DRAWER
1PC
E
BED RAIL
WITH HOLE
2PCS
L
BOTTOM
LADDER STEP
WITH DRAWER
1PC
F
BED RAIL
WITHOUT HOLE
2PCS
H
BOTTOM RAIL
WITH DRAWER
1PC
G
FLAT GUARDRAIL
SUPPORT
4PCS
NOTE:
Phillips head screw driver is required in the assembly process; however, manufacturer does not provide this item.
PARTS IDENTIFICATION
30 MINUTES
PAGE 2 OF 7
RIGHT
BED END
C 1PC
BACK RAIL
J
4PCS
B1 ( BOX 1)
B2 ( BOX 2)
B3 ( BOX 3 )
B4 ( BOX 4)
ASSEMBLY INSTRUCTIONS
ASSEMBLY TIPS:
1. Remove hardware from box and sort by size.
2.
Please check to see that all hardware and parts are present prior to start of assembly.
WARNING!
2.
This product is for home use only and not intended for commercial establishments.
1. Don’t attempt to repair or modify parts that are broken or defective. Please contact the store
immediately.
3. Please follow attached instructions in the same sequence as numbered to assure fast & easy assembly.
COASTERFURNITURE.COM
M