What to do if COBHAM Marine Equipment terminal restores factory settings and reboots the system?
If your COBHAM Marine Equipment terminal restores factory settings and reboots, press and hold the Reset button for 30 seconds. Keep holding it until the Power indicator on the terminal starts flashing orange.
How to initiate software upload on COBHAM Marine Equipment if firmware is missing or corrupted?
If the firmware on your COBHAM Marine Equipment is missing or corrupted, you can initiate a software upload by pressing and holding the Reset button while the terminal is booting.
How to reset COBHAM Marine Equipment terminal IP address and IP netmask to default?
To reset the IP address and IP netmask on your COBHAM Marine Equipment terminal to their default values, simply press the Reset button normally.
General| Type | FleetBroadband terminal |
|---|---|
| Satellite System | Inmarsat |
| Power Supply | 10.5 - 32 V DC |
| Frequency Band | L-band (1525-1559 MHz for receive, 1626.5-1660.5 MHz for transmit) |
| Data Rate | Up to 432 kbps |
| Voice | Yes, supports voice calls |
| Interfaces | Ethernet, USB, ISDN, Analogue Phone |
| Operating Temperature | -25°C to +55°C |
| IP Rating | IP56 |
| Compliance | Inmarsat FleetBroadband |
To Next Page
