Operation
10
Using Dual watch (requires priority channel is programmed)
• To activate Dual watch, press the SCN key.
The display shows “Dual” at the top and “D” at the bottom right.
The radio toggles between the selected channel and channel D (if
channel D is programmed as the priority channel).
• To terminate Dual watch, press SCN again.
Scanning channels
• To activate scanning memory, press 2 times SCN within ½ a second.
During scanning, the display shows “SC” in the channel field. The
radio toggles between channel D and each of the channels are
marked for scanning (only if a priority channel, e.g. D was
programmed).
• To terminate scanning, press SCN once.
Changing the transmitter power
To change the transmitter power, press the Hi/Lo key. The display shows
“Lo” when power is set to low. Otherwise maximum power is used.
Locking the keypad
• To lock the keypad, press and hold the Light/Lock button. The display
shows a key symbol when the keypad is locked.
• To unlock the keypad, press and hold the Light/Lock button again.
0845
To Next Page
Loading...
Need help?
General
