Maverick Boat Group
3207 Industrial 29th St. • Fort Pierce, Florida 34946
(772)-465-0631 • cobiaboats.com
Bilge
Bilge Access
First, locate the controls on the electronic lift assist, labeled “Hatch”, mounted on the
starboard side of the tackle station directly across from the gunwale. Next, press and
hold the top button on the controls. This will cause the rear access to lift revealing the
bilge access. To lower the hatch simply press and hold the bottom button on the control
panel until the aft section is fully closed. Remember that the electronic lift assist
operates using the house battery system.
In the event that the boat does not have power to electronically lift the hatch, the
electronic lift can be disengaged by lowering the bench seat and using the access
opening shown below to remove the pin from the electronic ram. Keep in mind that at
this point the hatch will no longer be supported in the up position and will require being
held up to maintain access to the bilge. Once the work in the bilge is finished and power
is restored to the hatch lift, it is important to attach the ram to the hatch with the pin
once again to secure the door in the closed position.
To Next Page
Loading...
