www.cobratools.com
Do not operate a machine that has the belt guard
removed, any absent or broken parts, or that is
inadequately assembled. If your machine does not meet
all of the conditions in this section, do not operate until the
machine is properly repaired (See Service Section). Failure
to properly prepare for operation may result in shock, re,
and/or serious personal injury or death.
Check your Personal Protective Equipment
Be sure your personal protective equipment (See Personal
Protection Equipment Section) is in good condition. Before
use, ensure gloves are not damaged.
Prepare the Work Area
• Make sure the work area has satisfactory lighting.
• Do not work in areas that have combustible liquids, dust
or vapors that may ignite. The drain machine is not
explosion resistant and can create sparks.
• Do not work in any area until all the amable soruces
have been identied and corrected.
• Never place the machine in water. If necessary remove
the water from the work area prior to use.
• Be sure the electrical outlet is properly grounded.
If unsure, have the outlet inspected by a licensed
electrician.
• Make sure the path for the power machine
transportation and power cord are clear of obtsructions.
Any potential sources of damage to the power cord or
machine should be relocated prior to use.
• Keep bystanders and childred away from the work area.
• Drain cleaning can be messy. If necessary, use
protective covers.
Inspect and Prepare the Drain
1
2
1
1
4
3
1
• Determine if
cleaning
chemicals have
been used in the
drain. If chemicals
are present,
contact the
chemical
manufacture to
understand the
safety measures
that are necessary
to work around
those substances.
• Properly inspect
the drain. Determine the best access point to the drain
and the size of the drain. If possible, determine the
distance to the blockage or the nature of the clog. If
necessary, remove the xture (water closet, sink, etc.) to
allow access to the drain.
Inspect and Prepare the Machine
• Verify machine and components are in place.
• Inspect your drain cleaning gloves to ensure they are in
good condition with no holes, tears or loose sections.
It is critical to have the proper gloves to protect your
hands from the rotating cable.
• Make sure the drain cleaning machine is unplugged
and inspect the Ground Fault Circuit Interrupter, plug
and power cord for any damage. If the plug has been
modied or is missing any components, do not use
the machine. It will need to be repaired by a qualied
person prior to use.
• Ensure the foot switch is attached to the machine
properly. Do not operate the machine without the foot
switch.
• Install wheels by inserting the wheel into the frame.
(See gure A )
• Before use, clean any grease, dirt or oil off the
equipment controls and handles. This will reduce the
risk of the machine or controls slipping from your grip.
• Conrm that the machine is accurately assembled.
Look for any parts that are not in a condition which
would prevent safe and normal operation.
• Rotate the drum and make sure that it smoothly rotates.
If any problems are found, or if you are unsure, do not
use the machine until it has been properly repaired.
• Ensure that the belt guard is fastened securely to the
machine. Do not operate without the guard properly
assembled.
• Make sure the warning label on the motor is intact
and readable. Do not operate the machine without the
warning label.
• Clean any debris from the tools and cable while
inspecting the cable for any wear and damage.
• Check for ats on the outside of the cable, if any
portion looks as though it is not round, the cable should
be replaced. Inspect the cable for any kinks, space
between the coils or excessive corrosion. These can
weaken the cable during use.
• Inspect the cutting tools for any damage or wear. If
damage or wear is found the tools need to be replaced.
• Conrm that the FOR/OFF/REV switch is in the OFF
PREPARATION FOR OPERATION
gure A
To Next Page
Loading...