EasyManuals Logo

Cobra 19 DX III User Manual

Cobra 19 DX III
14 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
11
Ignition Noise Inte rfe re n c e
Use of a mobile re ce i ver at low signal levels is nor-
mally limited by the pre s e n c e of elect ri cal noise.
Under most ope r ating co n d i t i o n s,when signal
l evel is adequate,the backg r ound noise does not
p re s e nt a serious pro b l e m .Al s o,when ext re m e l y
l ow level signals are being re ce i ve d ,the tra n s ce i ve r
m ay be ope rated with vehicle engine turned off.
The unit re q u i res ve ry little curre nt and there fo re
will not significa ntly discharge the vehicle bat te ry.
Even though this radio has an auto m atic noise lim-
i te r ,in some installations ignition inte rfe re n c e may
be high enough to make good co m m u n i cat i o n s
i m po s s i b l e.Consult your CO B RA dealer or a 2-way
radio technician for help in locating and co rre ct i n g
the source of seve re noise.
Te m po ra ry Mobile Ope rat i o n
For te m po ra ry mobile ope rat i o n ,you may wa n t to
p u rchase an additional cigare t te lighter adapte r
f rom your CO B RA dealer.This adapter and a mag-
netic mount antenna allow you to quickly "install"
your tra n s ce i ver for te m po ra ry use.
O p e r a t i o n
Ignition Noise
Interference
Temporary
Mobile
Operation
Note
Red wire is co n n e cted to po s i-
t i ve side of soc k et ce n ter tip.
Black wire is co n n e cted to ne
g
a t i ve side co n t a ct s.
Note
Radio resets to CH 9 when co n
n e cted to cigare t te lighter plug
Note
When using the unit with cig-
a re t te adapte r,turn off when
not in use to avoid draining
the batte ry.
10
Rear Pa n e l
Antenna Co n n e cto r.This female connector per-
mits connection of the transmission line cable
male connector to the transceiver.
Exte rnal Spe a ke r.The External Speaker Jack is
used for an external speaker.The external speak-
er should have 8-ohm impedance and be rated
to handle at least 4.0 watts.When the external
speaker is plugged in,the internal speaker is
automatically disconnected.
Powe r : These wires supply power to the CB ra d i o.
This cable is pe rm a n e n tly attached to the ra d i o.If
you wish to re m ove the radio after installat i o n ,d i s-
co n n e ct at fuse holder and ground co n n e cto r.
Public Ad d re s s : An external PA speaker may be
connected to the PA speaker jack when used as a
public address system.The speaker should be
directed away from the microphone to prevent
acoustic feed-back.Physical separation or isola-
tion of the microphone and speaker must be
employed when operating the PA at high
output levels.
Antenna
Connector
O p e r a t i o n
External
Speaker
Power
Note
Co b ra external spe a kers are
ra ted 15 wa t t s
19 DX III. LAYOUT(4478) 8/9/00 4:35 PM Page 10

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cobra 19 DX III and is the answer not in the manual?

Cobra 19 DX III Specifications

General IconGeneral
BrandCobra
Model19 DX III
CategoryRadio
LanguageEnglish

Related product manuals