29 LTD CLASSIC
Operation Operation
Setting Squelch
Squelch (SQ) is used to cut off or eliminate
background noise in the absence of an
incoming signal (when you are not talking).
1. Full clockwise rotation closes the “gate”
allowing only very strong signals to enter.
2. Full counterclockwise rotation opens
the “gate” allowing all signals in.
3. To achieve the Desired Squelch Setting
(DSS), turn the Squelch control
counterclockwise until you hear noise.
Now turn the control clockwise just until
the noise stops. This is the DSS.
10
English
11
29 LTD CLASSIC
29 LTD CLASSIC
To Transmit
1. Select the desired channel.
CAUTION:
Be sure the antenna is properly
connected to the radio before transmitting.
Prolonged transmitting without an antenna
or a poorly matched antenna could cause
damage to the transmitter.
Be sure to read the FCC Part 95 Rules and
Regulations before transmitting.
29 LTD CLASSIC
PUSH
AM/FM
FM
NOR
29 LTD CLASSIC
Set Dynamike
®
This controls the microphone sensitivity
(outgoing audio level).
2. Initially, set fully clockwise so that the
maximum voice volume is available.
Dynamike
®
may have to be reduced in
some conditions.
3. Push and hold the mic button to transmit.
When transmitting, hold the microphone
two inches from your mouth and speak in
a clear, normal voice. Release the mic
button to receive.
NORMAL
29 LTD CLASSIC
PUSH
AM/FM
FM
RF Meter
This meter swings proportionately to the RF
output (outgoing signal) while transmitting.
The S/RF-SWR-CAL switch must be in the
S/RF position.
External Speaker
Connecting an external speaker can provide
louder and clearer incoming audio.
Connect an external speaker to the external
speaker jack
on the rear panel.
NOTE:
The external speaker should have
8-ohm impedance and be rated to handle
at least 4.0 watts. When the external
speaker is plugged in, the internal speaker is
automatically disconnected.
Cobra external speakers are rated at 10 watts.
To Next Page
Loading...
Need help?
General
