Operation Operation
12
English
13
29 L
29 LTD CLASSIC
PA (Public Address)
1. Connect an external PA speaker to the PA
jack on the rear panel.
NOTE:
The speaker should have 8-ohm
impedance and be rated to handle at least
4.0 watts.
2. Set the CB/PA switch to the PA position.
NOTE:
The speaker should be directed away
from the microphone to prevent acoustic
feedback.
3. Push and hold the microphone button and
speak in a normal voice. Your voice will
now transmit through the PA speaker.
4. Adjust the PA speaker volume with the
Dynamike
®
control.
Base Station Operation
(From 120V AC House Current)
To operate the transceiver from home or
office you will need a 13.8 volt DC Power
Pack rated at a minimum of 2 amps, and a
properly installed base station antenna.
WARNING:
Do not attempt to operate this
transceiver by connecting it directly to 120VAC.
1. Simply connect the red (+) and black (-)
leads of the transceiver to the
corresponding terminals of the power
pack.
2. Plug the power cable into the back of
the unit marked “Power”. Be sure to
observe polarity markings.
3. Connect a properly installed and matched
base station antenna.
Temporary Mobile Operation
For temporary mobile operation you may want
to purchase an optional automobile power
adapter from your Cobra dealer. This adapter
and a magnetic mount antenna allow you to
quickly “install” your transceiver for temporary
use.
To Next Page
Loading...
Need help?
General
