Set DCS Privacy Codes
•
To select a DCS privacy code:
1. After selecting a channel, press the Mode/Power
button until the DCS icon appears and the small
numbers flash on the display (01 through 83).
2. Press the Channel Up or Channel Down button to select a DCS privacy
code. You can hold the Up or Down button for fast advance.
3. When DCS privacy code is displayed, choose one of the following:
a. Press the Mode/Power button to enter the new setting and
proceed to other functions.
b. Press Talk/Call button to return to Standby mode.
c. Do not press any buttons for 6 seconds to return to Standby mode.
External Speaker/Microphone/Charge Jack
•
Your microTALK radio can be fitted with an optional
external speaker/microphone (not included), freeing
your hands for other tasks.
To attach an external speaker/microphone or
charger
1. Open the charge tab at the top of the radio.
2. Insert the plug into the jack.
DCS Privacy Code
If CTCSS is turned on at the channel
selected, the display will flash the DCS
icon and “OFF.” To switch from CTCSS to
DCS, press the Channel Up or Channel
Down button while the display is flashing
“OFF.” The display will then show the
small numbers flashing and you will then
be able to proceed to step 2.
To Next Page
Loading...
Need help?
General
