Product Features
Using Your Radio
English
18
Memory Scan
•
Your microTALK radio can automatically scan the stored memory
locations.(See page 12 for setting memory locations)
To scan memory locations:
1. Make sure 2 or more memory locatios
programmed already.
2. Press and release the MEM/ESC button to enter
Memory mode from Standby mode.
Memory icon and the Memory Location show
on the display.
3. Press and release the Scan button, then the
Scan icon will flash on the display.
Then press Scan button again, Scan icon
and Memory icon will flash on the display
simultaneously.
4. Press the Channel Up or Channel Down button
to begin scanning stored channel locations.
The Scan icon will continue to be displayed when
Memory Scan is On.
Your radio will continue to scan memory locations
and stop as an incoming transimmision is detected.
Your radio will remain on that stored channel/
privacy code for 6 seconds.
To Next Page
Loading...
Need help?
General
