English
17
Nothing Comes Close to a Cobra
®
Privacy Code Scan
•
Your microTALK radio can automatically scan the Privacy Codes (either
CTCSS 01 through 38 or DCS 01 through 83) within one channel. Only
one set of privacy codes (CTCSS or DCS) can be scanned at a time.
To scan privacy codes:
1. While in Standby mode, press and release the
Scan button twice (CTCSS) or three times (DCS)
until the CTCSS or DCS icon and numbers are
flashing.
2. Press and hold the Scan button to begin scanning
privacy codes within the selected channel.
The Scan icon will continue to be displayed when privacy code scan
is on. Your radio will continue to scan privacy codes and stop as an
incoming transmission is detected. Your radio will remain on that
channel/privacy code for 6 seconds.
During scanning (while receiving an incoming transmission), you can choose
from the following:
a. Press and hold the Talk button to communicate on that channel/privacy code. Your
radio will remain on that channel/privacy code and return to Standby mode.
b. Press the Channel Up or Channel Down button to resume scanning privacy codes.
If you do not press any button within 10 seconds, your radio will automatically
resume scanning privacy codes.
c. Press the Scan button to return to Standby.
Select Channel
Scan Privacy Codes
To Next Page
Loading...
Need help?
General
