Always make sure to check your battery before charging to verify its type and the correct
charging mode required.
1. When the charger is rst plugged into a suitable electrical outlet it will enter standby mode and
the standby power indicator will illuminate orange.
2. Press the mode button to cycle through to the desired charging mode. For 6V and Low Voltage
charging modes, press and hold the mode button for two (2) or six (6) seconds depending on
which mode you wish to enter.
3. Once the desired charge mode has been selected the LED status light will illuminate (depending
on the health of the battery) and begin blinking orange to indicate that charging has started. For a
more detailed list on the LED status light readout, refer to the table on the following page.
4.
Charging is completed when the LED status light shows a solid green readout. At this point you can
either remove the battery charger or leave it connected in order to provide maintenance charging.
Charging Your Battery
6
Verify your battery’s voltage
and type
Select the desired battery voltage
and type on the battery charger by
pressing the mode button to cycle
through
12V
Lithium-Ion
Charging has begun when the
LED status light begins to blink
orange
When charging is complete (solid
green light) you can safely leave the
charger connected to maintain a full
charge or disconnect and store for
future use
To Next Page
Loading...