Cobra DG450 - Engine Stopping and Specifications; Stopping the Engine

- 4 -
Warning
Each successive electronic ignition time can not exceed 10 seconds; this will affect the service life of the battery.
Manual pull start operation
2) Move the throttle to the choke position, engage the “Brake control handle”, then grasp the starter grip handle, pull
slowly until resistance is felt then pull cord rapidly to overcome compression prevent kickback and start engine.
A. Cable hole
A2. FOR RESTARTING A WARM ENGINE:
Do not use the choke when the engine is warm. Move the throttle control slightly past the choke position you can
choose one of
The following two methods can start the engine.
1) Engage the brake control handle, insert the key switch lock, then the positive clockwise for electronic ignition
operation.
2) Engage the brake control handle, grasp the starter grip handle and pull slowly until resistance is felt then pull
cord rapidly to overcome compression prevent kickback and start engine.
B1. FLYWHEEL BRAKE MODELS:
Move the throttle to the choke position engage the starter control handle (located on the equipment) to release the
flywheel brake.
The engine will stop if you release the brake control handle.
Do not allow the starter grip to snap back against the engine.
Return it gently to prevent damage to the starter.
B2. FLYWHEEL BRAKE MODELS:
Continue to hold the brake control handle (located on the equipment). The engine will stop if you release the
starter control handle.
STOPPING THE ENGINE
1. Turn the fuel valve to the OFF position
2. Flywheel brake models :
Release the brake control handle (located on equipment) to stop the engine.