Oil Level Check
1. Check the oil with the engine stopped and level.
7. Oil filler cap/dipstick
Max: upper limit
Min: lower limit
2. Remove the oil filler cap/dipstick and wipe it clean with a clean rag to prevent dirt deposits contaminating fuel.
3. Insert
the
oil
filler
cap/dipstick
into
the
oil
filler
neck
as
shown,
but
do not screw it in, then remove it to check the oil level.
4. If
the
oil
level
is
near
or
below
the
lower
limit
mark
on
the
dipstick, remove
the
oil
filler
cap/dipstick,
and
fill
with
the
recommended
oil to
the
upper
limit
mark
(bottom
edge
of
.the
oil
fill
hole).
Do
not
overfill.
5. Reinstall the oil filler cap/dipstick.
6. Clean up any oil you may have spilled
Oil Change
This engine is delivered without oil, be sure to put oil in the engine before the starting. Use a clean, detergent
and high quality oil SAE30 and API. SG, SH OR SJ classification.
Drain the engine oil when the engine is warm, warm oil drains quickly and completely.
7. Oil filler cap/dipstick
A: Sealing washer
B: Drain bolt
1. Turn the fuel valve to the OFF position to reduce the possibility of fuel leakage
2. Place a suitable container next to the engine to catch the used oil.
3. Remove the drain bolt and drain the oil into the container by slightly tipping the engine toward the oil filler cap/dipstick.
Please dispose of used motor oil in a manner that is compatible with the environment. We suggest you take used oil in a
sealed container to your local recycling center or service station for reclamation. Do not throw it in the bin or pour it on the
ground
or down a drain.
4. With the engine in a level position, fill to the upper limit mark on the dipstick with the recommended oil (see below). Engine
Oil Capacity:
0.63 US qt (0.60L)
Running
the
engine
with
a
low
oil
level
can
cause
engine
damage.
Reinstall
the
oil
filler
cap/dipstick
securely.
To Next Page
Loading...