Petrol is highly flammable and explosive, take care when refueling as you can burn or seriously injure yourself.
Stop engine and keep heat, sparks, and flame away. (never smoke when refueling)
Wait at least 15 minutes for the engine to cool
Refuel only outdoors.
Wipe up spills immediately.
If fuel is spilt on the machine or engine wipe up immediately and wait for vapors to dissipate before
restarting.
Fuel can damage and corrode some paint and some types of plastic. Always be careful not to spill fuel when
re-fueling your fuel tank. Any damage caused by spilled fuel is not covered under the Warranty.
Always use the specified fuel. Never use stale or contaminated petrol or oil mixture. Avoid getting dirt or
water in the fuel tank.
Adding Fuel
1. Carefully remove the fuel tank cap.
2. Fill the tank to the bottom of the fuel level limit in the neck of the fuel tank. Wipe up spilled fuel before starting the
engine.
Never overfill.
Fuel tank capacity:
DG450:
0.32gal (U.S) (1.2L)
DG550: 0.53gal
(U.S)
(2.0L)
Adding Fuel
2: Fuel tank cap
ENGINE OIL
Use 4-stroke motor oil that exceeds or meets the requirements for API service classification SH, SJ, or equivalent.
Always check the API service label on the oil container to be sure it includes the letters SH, SJ, or equivalent
Always change the oil at the required service interval.(please refer to the maintenance schedule)
SAE 10W-30 is recommended for general use.
To Next Page
Loading...