COMPLETE INSTRUCTIONS
G100
59
CAUSE OF THE ALARM
1 flash doors/boot opened
ultrasonic volumetric sensor
triggered
3 flashes
bonnet opened
4 flashes
start -up attempts
(ignition key)
5 flashes
6 flashes
2 flashes
speed input sensor I addiotional
sensors triggered
not used
7 flashes
8 flashes
9 flashes
10 flashes
not used
satellite anti- theft disconnected (ICD30)
LED SIGNALS
4310 siren disconnected (wires cut OFF)
outside module disconnected
(wires cut OFF)
17 - HOW TO CONFIGURATE POSITIVE PERIMETRICAL INPUT.
Enable line 6 page 2 on the basic tables functions following the instructions written on the
reverse side (see paragraph 15 on “How to programme the G100 sytem”).
18 - ALARM RECORD.
When it is being disarmed, the system reports if there has been an alarm by four acoustic
and visual signals emitted by the direction indicators and buzzer. Pay attention to the LED
signals that remain available until the next time the system is armed or until the ignition is
turned ON. The signals (number of flashes) identify the cause of the alarm.
To Next Page
Loading...
