Need help?Do you have a question about the Cobra GLOBE 3100 and is the answer not in the manual?
Lists the European directives the system conforms to.
Lists main alarm features that cannot be activated/deactivated or personalized.
Lists functions requiring programming based on vehicle model and desired alarm operation.
Describes test operations for the volumetric ultrasonic sensor, generating an alarm status upon completion.
Details test operations for perimetric protection, involving arming the alarm and testing door/bonnet/boot openings.
Explains the VSS signal and its connection requirements for the alarm system.
Describes how to connect central door locking control wires for various CDL systems.
Lists particular functions that can be programmed according to desired alarm operating modes.
Explains how to configure the horn/siren output for different sound options.
Details the functions of the remote control buttons (A and B) for alarm operation and programming.
Instructions for fitting the alarm unit in the passenger compartment, ensuring proper connector orientation.
Guidance on mounting sirens (self-powered/non-self-powered) in the engine bay and fixing them.
Details on positioning ultrasonic transducers for optimal coverage without adjustment.
Recommendations for microphone placement for uniform sensitivity and use with ultrasonic sensors.
Steps to follow when both remote controls are lost, including PIN entry and system re-learning.
Guide on initiating the system's programming mode by disarming and turning ignition ON.
Instructions on navigating between different programming tables by cycling the ignition.
Steps to activate or deactivate a specific function within a selected programming table.
Procedure for exiting the programming mode, typically by closing the bonnet.
Lists programmable functions requiring setup based on vehicle model and desired alarm operation.
Lists particular functions that can be programmed according to specific alarm operating modes.
Explains selecting intermittent horn output or specific siren sounds for models 3193/3191/3192.
Details the functions of remote control buttons A and B for alarm operation and programming.
Explains the tachograph signal and its connection to the alarm system for speed-proportional functions.
Describes the different connection configurations available for controlling central door locking systems.
Guides on performing tests for the ultrasonic sensor within 40s of inhibition, checking LED response to movement.
Details tests for perimetric protection, involving arming the system and checking door/bonnet/boot openings.
Explains the manual's purpose to install and set up the alarm, directing to user manual for function details.
Outlines essential requirements for obtaining Category 1 status, including immobiliser compatibility.
To Next Page
General