14
3.4 CONNECTING THE BATTERY
The electrolytic fluid is a solution of sulphuric acid.
Danger: Sulphuric acid is poisonous
Danger: Sulphuric acid is corrosive Sulphuric acid can cause blindness or severe burns.
Danger: Keep out of reach of children.
For EU countries only
Never place any electric power tools in your household refuse.
To comply with European Directive 2012/19/EC concerning old electric and electronic equipment and its
implementation in national laws, old electric power tools have to be separated from other waste and disposed of
in an environment-friendly fashion, e.g. by taking to a recycling depot.
Fit the battery in its housing.
IMPORTANT
Position the battery with the polarities（+）and（—）
Connect the battery connectors to the machine connection leads
and tighten the 2 screws. then cover the protective cap for the 2
wire is in place. (Use the open end wrench 8-10 and cross
screwdriver in accessories tools)
1)
Secure the battery with the small rubber strap.
The battery type:
12 V 18Ah.
The battery is fully charged before leaving the factory.
If the battery is found to be insufficient, please use a 12V1A
charger to charge the battery.
3.5 MOUNTING THE FRONT BUMPER
Mounting the bumper bracket L and bumper bracket R on the
bumper, using 4 nuts and 4 screws. (Use the open end wrench
13-15 in accessories tools.)
Mounting the front bumper on the bottom of the frame using the
4 nuts and 4 screws. (Use the open end wrench 13-15 in
accessories tools.)
To Next Page
Loading...