27
3.
The blades must be in good condition and well sharpened so that the grass is cut straight without a ragged
edge that leads to yellowing at the ends.
4.
The engine must run at full speed, both to ensure a sharp cut of the grass and to get the necessary thrust to
push the cuttings through the collector channel.
5.
The frequency of mowing should be in relation to the rate of growth of the grass. The grass should not be left
to grow too much between one cut and the next.
6.
During hot and dry periods, the grass should be cut a little higher to prevent
the ground from drying out.
7.
The best height of the grass on a well-kept lawn is approx. 4-5 cm. With one
cut, you do not need to remove more than a third of the total height. If the grass is
very tall, it should be cut twice in a twenty-four hour period – the first time with the
blades at maximum height, possibly reducing the cutting width, and the second
cut at the desired height.
8.
When you mow large areas, start by turning to the right so that the cut grass will discharge away from shrubs,
fences, drive-ways, etc. After one or two rounds, mow in the opposite direction making left turns until finished
9.
The appearance of the lawn will improve if you alternate cutting in both directions.
10.
If the collector system tends to get blocked with grass, you should reduce the forward speed as it may be too
high for the condition of the grass. If the problem persists, the probable causes are either badly sharpened blades
or deformed blade wings.
11.
Be very careful when mowing near bushes or kerbs as these could distort the horizontal position of the
cutting deck and damage its edge as well as the blades.
6 MAINTENANCE
6.1 SAFETY RECOMMENDATIONS
Before cleaning or doing maintenance work, take out the ignition key and read the relevant
instructions. Wear appropriate clothing and work gloves whenever your hands are at risk.
Never use the machine with worn or damaged parts. Faulty or worn-out parts must always
be replaced and not repaired. Only use original spare parts: Parts that are not of the same quality can
damage the equipment and affect your safety and that of others
Never dispose of used oil, fuel, batteries or other pollutants in unauthorised places!
To Next Page
Loading...