30
6.4.4 Dismantling, replacing and remounting the blades
Always wear work gloves when handling the blades. Before you
inspect or remove the
blade, stop the engine and disconnect the wire to the spark plug.
Damaged or bent blades must always be
replaced; never try to repair them!
ALWAYS USE ORIGINAL BLADES
Make sure the blades are correctly balanced. The blades are
different and rotate in different directions, so make sure you put
them back in the right place by referring to the code stamped on the
outside of each blade.
Step 1 – Removing the Blades
1a - screw with right thread (loosen anti-clockwise)
1b - screw with left thread (tighten clockwise)
Step 2- Refitting the Blades
Check that the concave part of the cushion disc (3) presses
against the blade. Remount the shaft hubs (4), making sure that
the keys (5) are securely lodged In place.
Step 3 - Tightening the Bolts
1a = screw with right thread (tighten clockwise)
1b = screw with left thread (tighten anti-clockwise)
Tighten with a torque wrench calibrated to 40-45 Nm.
6.4.6 Replacing the belt
The belt replacement must be carried out at a Cobra Service
Centre. Replace the belts as soon as they show obvious sign of
wear!
ALWAYS USE GENUINE REPLACEMENT BELTS!
To Next Page
Loading...