Cobra LT86MRL - UNEVEN OR POOR CUTTING RESULTS

35
Strong vibrations
2. Engine loose.
Check and tighten all the engine and frame bolts
3. Unbalance in one or
both blades resulting
from damage.
Contact your Dealer or Service center.
4. Cutting-deck
assembly is full of grass
Clean the cutting-deck assembly
5.Engine mounting not
securely tightened
Tighten engine mounting or contact your Dealer or Service center.
6. Belt damaged
Replace Belt
Problem
Possible cause(s)
Remedy
Uneven or poor
cutting results
1. Blades blunt or worn
Sharpen or replace mowing blades
2. Different air
pressures in tires on left
and right side.
Check the tyre pressure.(par. 5.3.2)
3.Cutting deck
adjustment.
Check deck adjustment (6.3 or
Contact your Dealer or Service center)
4.Long and/or wet
grass
Adapt cutting level and driving speed to the mowing conditions.
5.Travelling speed too
high.
Set to a lower travelling speed.
6. Grass stuck under
cutting deck
Cleaning inside the deck properly (Use a suitable accessory to
access the cleaning of the cutting deck)
7.Cutting drive belt
Slipping
Replace the cutting drive belt
8.Collector channel is
blocked.
Remove the grass catcher and empty the discharge chute
If problems persist after having performed the above operations, contact your Dealer or Service center.