CTCSS Privacy Code Scan
Your microTALK
®
radio can automatically scan the CTCSS privacy codes (01 to 38) within
one (1) channel.
To Scan Privacy Codes:
1. While in LISTENING MODE, press the CHANNEL UP or CHANNEL DOWN button to choose the channel
on which you wish to scan the CTCSS privacy codes.
2. Press the MODE button until the Scan icon and the small numbers next to the channel number flash
on the display.
3. Press the CHANNEL UP or CHANNEL DOWN button to begin scanning CTCSS privacy codes within the
channel you selected.
The Scan icon will continue to be displayed when CTCSS privacy code scan is On. Your radio will
continue to scan CTCSS privacy codes and stop as an incoming transmission is detected. Your radio will
remain on that channel/privacy code for ten (10) seconds.
While setting CTCSS privacy code scan, if you do not press any buttons for fifteen (15) seconds your radio will automatically return to LISTENING
MODE on the channel/privacy code that was displayed before you entered Mode Functions.
During An Incoming Transmission, You Can Choose From The Following:
a. Press and hold the TALK button to communicate on that channel/privacy code. Your radio will remain on that channel/privacy code and
return to LISTENING MODE.
b. Press the CHANNEL UP or CHANNEL DOWN button to resume scanning CTCSS privacy codes.
If you press the TALK button while scanning and not within ten (10) seconds of receiving a transmission, you will transmit on the channel/privacy
code on which you last received a transmission. This will return the radio to LISTENING MODE.
If you do not press any button within ten (10) seconds, your radio will automatically resume scanning CTCSS privacy codes.
During Scanning (while not receiving a transmission), You Can Choose From The Following:
a. Press and hold the TALK button to communicate on either the channel or channel/privacy code that was displayed before you entered Mode
Functions or channel/privacy code on which, during scanning, you last received a transmission. This will return the radio to LISTENING MODE.
b. Press the MODE button to proceed to next available Mode Function.
c. Press the LOCK button to return to LISTENING MODE on either the channel or channel/privacy code that was displayed before you entered
Mode Functions or the channel/privacy code on which, during scanning, you last received a transmission.
“Roger Beep” Confirmation Tone
Your listener will hear an audible tone when you release the TALK button. This
alerts the other party that you have finished talking and that it is OK for them to
speak. This feature can be turned On or Off.
To Turn “Roger Beep” On or Off:
When you turn On your microTALK
®
radio for the first time, “Roger Beep”
will be On.
1. Press and release the MODE button until the “Roger Beep” icon flashes on the display. The current On or Off setting is displayed.
2. Press the CHANNEL UP or CHANNEL DOWN button to select “Roger Beep” On or Off.
English
MODE FUNCTIONS OPERATION
To Next Page
Loading...
Need help?
General
