47
Nothing Comes Close to a Cobra
®
VHF Marine Radio Protocols
Intro Operation Customer
Assistance
Warranty
Notice
Main Icons
Secondary Icons
Caution Warning
Installation
Customer
Assistance
Operating Your Radio
46
English
Intro Operation Customer
Assistance
Warranty
Notice
Main Icons
Secondary Icons
Caution Warning
Installation
Customer
Assistance
IntroductionVHF Marine Radio Protocols
Intro Operation Customer
Assistance
Warranty
Notice
Main Icons
Secondary Icons
Caution Warning
Installation
Customer
Assistance
Operating Your Radio
Memory Location Mode
Your radio has unlimited memory locations for storing your
most frequently used channels. These memory locations can
be selected individually or can be scanned. (See page 49 under
Memory Location Scan.)
To enter Memory mode, press MEM/ESC button. The display
will show the MEM icon and the Memory Channel bank will be
displayed on the matrix.
To Program Memory Locations:
1. Press and hold the MEM/ESC button for two (2)
seconds. The memory location number will be displayed
on the matrix and the MEM icon will be turned On.
2. Use the Channel Up/Down button to advance to the
memory location (00-99) you want to program.
3. Press the MEM/ESC button to select the memory
location.
4. Use the Band button to select the GMRS or
marine band.
5. Use the Channel Up/Down button to change to the
channel you want to store into the selected memory
location.
6. Press the MEM/ESC button to program that channel.
The memory location will be displayed on the matrix
again.
Repeat steps 2 through 5 to program as many additional
memories as you want.
7. Press and hold the MEM/ESC button for two (2)
seconds. This will return the radio to Memory mode.
8. Press and release the MEM/ESC button again to return
to Marine or GMRS Standby mode.
MEMSAMEVOX HI
ROG
VHF
GMRS
T
R
X
U
MEM/ESC Button
MEMSAME
VHF
U
A
Memory Location Number
MEMSAMEVOX HI
ROG
VHF
GMRS
T
R
X
U
Channel Up/Down Buttons
MEMSAME
VHF
U
A
Channel Number
To Recall a Stored Memory Location:
1. Press the MEM/ESC button. The MEM icon will be
turned On.
2. Press the Channel Up/Down button to select the
memory location. If a memory location has been
programmed, its associated channel will display on the
LCD. Your radio is now in Marine or GMRS Standby
mode on the selected memory location.
To Exit Memory Location Mode:
Press the MEM/ESC button to return the radio to Marine
or GMRS Standby mode. The last channel used in Marine
or GMRS Standby mode will now be displayed on the LCD
and the MEM icon will disappear.
To Erase Stored Memory Locations:
1. Press and hold the MEM/ESC button for two (2)
seconds. The memory location number will be displayed
on the matrix and the MEM icon will be turned On.
2. Use the Channel Up/Down button to advance to the
memory location you want to erase.
3. Press the MEM/ESC button to select the memory
location.
4. Use the Channel Up/Down button to change to the
channel to read “00” at the selected memory location.
5. Press the MEM/ESC button to erase that channel.
Repeat steps 2 through 5 to erase as many additional
memories as you want.
6. Press and hold the MEM/ESC button for two (2)
seconds. This will return the radio to Memory mode.
7. Press and release the MEM/ESC button again to return
to Marine or GMRS Standby mode.
MEM Icon
Advanced OperationAdvanced Operation
MEMSAMEVOX HI
ROG
VHF
GMRS
T
R
X
U
Band Button
To Next Page
Loading...
