- 17 -
12. TROUBLES SHOOTING
Throttle choke not in the correct
position for the prevailing conditions.
Move throttle choke to the correct position
Fill the tank with fuel: refer to the ENGINE
MANUAL.
Air filter element is dirty.
Clean air filter element: refer to the ENGINE
MANUAL
Tighten spark plug to 25-30Nm.
Spark plug wire loose or
disconnected from the plug.
Install spark plug wire on spark plug.
Spark plug gap is incorrect.
Set gap between electrodes at 0.7 to 0.8mm
Install new, correctly gapped plug: refer to the
ENGINE OWNERS MANUAL
Carburetor is flooded with fuel
Remove air filter element and pull starter rope
continuously until the carburetor clears itself and
then install the air filter element.
Contact the service agent.
Engine doesn’t start with the key
Engine difficult
to start or loses
power.
Dirt, water, or stale fuel tank.
Drain fuel and clean tank. Fill tank with clean,
fresh fuel
Vent hole in fuel tank cap is
plugged.
Clean or replace fuel tank cap.
Air filter element is dirty.
Clean air filter element.
Engine
operates
erratically.
Install new, correctly gapped plug: refer to the
ENGINE OWNERS MANUAL
Spark plug gap is incorrect.
Set gap between electrodes at 0.7 to 0.8mm
Air filter element is dirty.
Clean air filter element: refer to the ENGINE
OWNERS MANUAL
Air filter element is dirty.
Clean air filter element: refer to the ENGINE
OWNERS MANUAL
Air slots in engine shroud are
blocked.
Remove debris from slots.
Cooling fins and air passages under
engine blower housing are blocked.
Remove debris from cooling fins and air
passages.
Engine skips at
high speed.
Gap between electrodes of spark
plug are too close.
Set gap between electrodes at 0.7 to 0.8mm
Cooling air flow is restricted.
Remove any debris from slots in shroud, blower
housing, and air passages
Install NGK BPR6ES spark plug
Mower vibrates
abnormally
Cutting assembly is loose.
Cutting assembly is unbalanced
Balance or replace the blade