to monitor for activity. If leaving your vehicle off for more than 48 hours (or less if your battery is
old) please use the “Auto Surveillance Shutoff” setting to set a time-limit on Motion Detection
and prevent your battery from being drained.
Note: For Motion Detection to work the camera needs to be connected via hardwire kit (part:
CA-MICROUSB-001) or be plugged into an ‘always on’ Cigarette Lighter Socket. You can check if
your vehicle has an ‘always on’ CLA adapter online or in the vehicle’s owner’s manual.
Parking Mode:
Enabling Parking Mode allows your camera to monitor for changes in its internal G-
Sensor/accelerometer. Bumps, Collisions, and break-ins can trigger the G-Sensor to save
valuable footage from the moment of impact. If leaving your vehicle off for more than 48 hours
(or less if your battery is old) please use the “Auto Surveillance Shutoff” setting to set a time-
limit on Motion Detection and prevent your battery from being drained.
Note: For Parking Mode to work the camera needs to be connected via hardwire kit (part: CA-
MICROUSB-001) or be plugged into an ‘always on’ Cigarette Lighter Socket. You can check if your
vehicle has an ‘always on’ CLA adapter online or in the vehicle’s owner’s manual.
Surveillance Auto Shutoff:
If leaving your vehicle off for more than 48 hours (or less if your battery is old) please use the
“Auto Surveillance Shutoff” setting to set a time-limit on Motion Detection and Parking Mode to
prevent your battery from being drained.
G-Sensor:
You can use this setting to set the sensitivity of the G-Sensor from 1-3 or turn it off. Level 1 is the
easiest to activate the G-sensor. Level 3 is the setting which will only lock videos when the most
severe impacts are detected. Level 1 is recommended for most users.
Watermark (Date/Time, Speed, GPS, Driver ID Video Stamp
The watermark settings allow you to toggle having the date/time, speed, GPS coordinates, the
Cobra logo and a custom Driver ID be stamped into the bottom of all recorded video.
Driver ID Watermark:
This setting allows you to associate a Driver ID with the camera (for example: John, Employee 12,
etc). This allows you to set the name of the driver which will be stamped on the footage as part of
the watermark.
Exposure:
Allows you to adjust how light or dark videos and images will appear on the camera.
Button Beep:
Turns the sound on or off for button presses. Note: this only affects normal button presses. Error
messages or Voice Announcements are not affected by this setting.
Screen Saver:
To Next Page
Loading...
Need help?
General
