Cobra T24C User Manual

13 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

1

MODELS: T24C (SM-WG430-W01)

COBRA CULTIVATOR / TILLER

OWNER’S MANUAL

Cobra Garden Machinery

Henton and Chattell Ltd., London Road, Nottingham NG2 3HW UK

www.cobragarden.co.uk

Table of Contents

Questions and Answers:

M
Michael OchoaAug 2, 2025
What to do if my Cobra T24C Tiller engine starts but does not keep running?
- K
  Kathy JonesAug 2, 2025
  If your Cobra Tiller engine starts but doesn't keep running or is hard to restart, there are several potential causes. First, ensure you're using the correct fuel; if not, drain the incorrect fuel and refill with the right type. Also, check if the settings are out of the normal range and adjust them accordingly. Carbon buildup can also cause this issue, so wipe away any accumulated carbon. Lastly, check for dust clogs and wash or clean any affected parts.
M
Mallory ChangAug 16, 2025
How to fix starting failure in Cobra Tiller?
- D
  Dr. Aaron SmithAug 16, 2025
  If your Cobra Tiller fails to start, several factors could be the cause. Begin by checking the fuel; if it's incorrect, drain it and refill with the correct type. A clogged fuel filter can also prevent starting, so clean it thoroughly. Ensure that all settings are within the normal range and adjust if necessary. Inspect the spark plug for fouling or wetness; clean, dry, and correct the gap to 0.6 – 0.7 mm. Finally, check all connections to ensure they are tightly fitted.

Cobra T24C Specifications

General

Brand	Cobra
Model	T24C
Category	Tiller
Language	English

Summary

Safety Labels

Safety Instructions

Training

Key steps for new operators to familiarize themselves with controls and emergency stops.

Before You Start

Essential checks and precautions before operating, including protective gear and fuel safety.

Operation and Caution

Guidelines for safe operation, environmental conditions, slope handling, and emergency procedures.

Components

Technical Specification

Assembling and Adjustment

Assembly of Lower Handles

Attaching the lower handles and loosely tightening the hand wheel bolts.

Assembly of Upper Handles

Attaching the upper handles and loosely tightening the hand wheel bolts.

Fitting the Cover Plate

Securing the cover plate with nuts and bolts using spanners.

Tighten and Secure Fixings

Final tightening of hand wheels and other components for secure assembly.

Adjust Rear Wheel

Selecting the working height for the wheels based on operating conditions.

Operation

Add Oil and Fuel Mixture

Instructions for correctly mixing and adding fuel and 2-stroke oil to the engine.

Starting Procedure

Step-by-step guide for starting the tiller's engine, including choke and primer usage.

Maintenance

Engine Maintenance

Procedures for spark plug, air filter, and carburetor cleaning or replacement.

Idle Speed Adjustment

How to check and adjust the engine's idle speed using the adjustment screw.

Fuel System Checks

Checking fuel lines and filters for blockages and replacing them if necessary.

Exhaust and Cooling System

Checking exhaust condition and cleaning air cooling vents for optimal engine performance.

100-Hour Service

Tasks for every 100 hours of usage: exhaust, clutch lining, and drum checks.

Maintenance Schedule

Storage

Troubleshooting Guide

Starting Failure

Common causes and actions for when the tiller fails to start.

Engine Runs Poorly

Troubleshooting for engines that start but run poorly or are hard to restart.

Warranty

Environment

EC Declaration of Conformity