Alarm Mode
To set the alarm
The clock on your speaker system includes a dual alarm,
which can be set to two dierent wake times. The alarm
can be set at any time, even during audio playback. To set
the alarm:
Press and hold the SET pad until the hour display and 1.
‘A1’ begin to ash.
A1 denotes Alarm 1.
Select the alarm hour using the [ + ]/[ – ] controls. 2.
Press the SET pad to conrm selection. The minute
display will begin to ash.
Select the alarm minute using the [ + ]/[ – ] controls. 3.
Press the SET pad to conrm selection. The alarm
volume setting will begin to ash.
Select the alarm volume using the [ + ]/[ – ] controls. 4.
Press the SET pad to conrm selection.
The hour digits and ‘A2’ (denoting Alarm 2) will begin 5.
to ash. Repeat steps 2-4 to set Alarm 2.
To set the alarm type
You can select the alarm to wake you with a standard
‘BEEP’, AM/FM radio, or playback from your iPod. To
choose an alarm type, at least one alarm must be set and
activated. (Screen will display A/A.) The system speaker/
radio must be turned o.
To Next Page
Loading...
Need help?
General
