Getting Started
Installation
Connect the left and right channel speaker cables to 1.
the corresponding audio output jack on the system’s
rear panel.
Connect the 3.5mm wire control to the audio 2.
frequency output jack of the external device (CD
player, computer, TV, etc), and plug the RCA end into
the signal input jack of the main unit.
Conrm that all connections are correct and secure, 3.
then connect the power cable of the woofer to the
AC 120V 60Hz power supply.
For a detailed installation diagram, please see below.4.
This system connects to your indoor AC 120V, 60Hz
power supply.
To Next Page
Loading...
