© 2020 The Coca-Cola Company | Coca-Cola Freestyle® 7000 User Guide | Confidential information of The Coca-Cola Company | 20200821 |
17
cleaning and lling ice bin
How to properly check/fill ice
Maintaining the proper ice level is critical
to ensuring your guest receives a quality
beverage. If using a top-mount ice maker,
follow established procedures for checking ice
level. If you fill the ice manually, check to
ensure ice is at least 1/3 full at all times. Fill the
ice bin by following the steps illustrated below:
Fill a clean bucket with ice.
Safely lift and remove ice bin lid.
Dump the ice in the ice bin and fill until full.
(approximately 2" from the top – do not overfill)
Replace ice bin lid.
NOTE: Store bought or “bagged ice” SHOULD NEVER BE USED as it may
seriously damage the Coca-Cola Freestyle® 7000 dispenser ice bin.
/ full
/ full
full
Ice bin should NEVER be less
than one-third full
maintenance
Ice bin cleaning best practices
Remove ALL ice by using the ice dispense lever
(if a top mounted ice maker is installed, follow
manufacturer’s recommendation for cleaning).
Turn power o and unplug dispenser.
Remove ice bin lid.
Pour warm water slowly into the bin (not over
the ice chute) to melt the remaining ice on the
cold plate.
Spray approved sanitizer solution (Kay-5) onto
all internal surfaces of ice bin and both sides of
ice bin lid.
Clean areas within reach inside the bin with
either a clean cloth or an ice bin brush (small
parts #149322). Spray approved sanitizer
solution on all internal surfaces and lid again,
allow draining and air dry.
Return to normal operation.
NOTE: For complete disassembly instructions,
contact your Coke representative.
To Next Page
Loading...
Need help?
General
